tutorials:cad:start
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
tutorials:cad:start [2014/04/22 20:15] – magiero | tutorials:cad:start [2015/02/16 16:56] (current) – magiero | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== CAD ====== | ====== CAD ====== | ||
- | |||
- | ===== CSE Account Setup ===== | ||
- | |||
- | Email Jason Keltz (jas@cse.yorku.ca) about getting an account set-up on which you can run the CMC-brokered CAD tools. | ||
- | |||
- | ===== CAD Activate ===== | ||
- | Once you have your CSE account make sure to validate it with CMC such that you can use the tools that you or your supervisor has paid for. | ||
- | |||
- | From the command line type: | ||
- | |||
- | < | ||
- | / | ||
- | </ | ||
- | |||
- | And follow the directions appearing in the ensuing pop-up window. | ||
===== Cadence ===== | ===== Cadence ===== | ||
- | We have partitioned our Cadence tools among the IC technology we wish to explore with it and the Cadence version number we wish to run. To avoid problems create a directory from which you will run one (and only one!) Cadence start-up command (listed below). | + | We have partitioned our Cadence tools among the IC technology we wish to explore with it and the Cadence version number we wish to run. To avoid problems create a directory from which you will run one (and only one!) Cadence start-up command (listed below). |
- | ==== Start-Up Commands ==== | + | {{:tutorials: |
- | + | ||
- | - cad-1805: | + | |
- | - cad-1806: | + | |
- | - cad-ibm51: IBM's 130-nm CMOS technology running on Cadence Virtuoso v5.10.41. | + | |
- | - cad-ibm6: | + | |
- | - cad-tsmc905: | + | |
- | - cad-tsmc906: | + | |
- | - cad-tsmc655: | + | |
- | - cad-tsmc656: | + | |
- | - sim-nc: Run the nc-verilog simulator. | + | |
- | - sim-ncg: Run the nc-verilog simulator with GUI. | + | |
- | + | ||
- | + | ||
- | {{t1analogbasics.pdf | Tutorial 1: Basic Analog Simulation in Cadence}} | + | |
===== Synopsys ===== | ===== Synopsys ===== | ||
- | |||
- | ==== Start-Up Commands ==== | ||
- | |||
- | - '' | ||
- | - '' | ||
- | - '' | ||
- | - '' | ||
- | - '' | ||
- | - '' | ||
- |
tutorials/cad/start.1398197758.txt.gz · Last modified: 2014/04/22 20:15 by magiero