EE Teaching Labs

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== PRISM LABS ======

  * [[LAS1002 Prism Teaching Lab (PTL):]]
  * [[LAS1004 Generalized Signal Processing (GSP) Lab:]]
  * [[LAS1006  Eshrat Arjomandi (EA) Lab:]]


=== Lab Safety ===
For all the Engineering labs, a Health and Safety presentation is made, during the first lab of the term. Here the students are made aware of: \\
- University's safety policies and procedures \\
- Available Health, Safety and Well-being resources, available to students on campus \\
- Expectations from them, regarding safe working in the labs \\

=== University Health and Safety Resources ===

- For more information on University's **//Health, Safety and Well-being//**, visit  [[https://hr.info.yorku.ca/health-safety-employee-well-being/|this page]]. \\

- For information on University's Phased Return to Campus, during COVID-19, **//YU Better Together//** please check out [[https://yubettertogether.info.yorku.ca/|this link]].

=== Technical Resources ===

== EECS3201 / EECS 3216 Digital Design and Digital System Courses ==

**Note:** The following two tutorials are oriented towards **WindowsOS**. For **MacOS** see the next section. 

__Installing Software and Drivers__\\
This tutorial describes how to install Intel (Altera) Quartus Software, ModelSim, fpga 
Devices, related Drivers and to Verify your setup

The tutorial is specifically for **//Quartus version 20.1 and for Max 10 family//** of FPGA 
devices. You would have to alter the steps, if using a different version and device family.

To download the tutorial, click {{:tutorial_quatusinstallandverify.pdf|here.}}  


__ModelSim Simulator__\\
This tutorial explains running **//ModelSim simulator//**, from within the Quartus project, to 
simulate and verify your Digital Design.

Download the tutorial {{:tutorial_modelsimfromquartus.pdf|from here.}}\\
Click on this {{:modelsimtutorialfiles.zip|link}} for the verilog files used in this tutorial.

**__//Steps for MacOS//__** 
Running Quartus and ModelSim on MacOS is __Not__ natively supported. However there are few work-arounds, which have been tried and tested. \\ \\
Follow the steps in this {{:tutorial_macos.docx|document}} to correctly install and setup Quartus and Modelsim when using a MacOS computer. 

__Interactive Tutorials__\\
  * Check out this [[https://www.aldec.com/en/downloads|external link]] from Aldec, for Interactive Tutorials on VHDL and Verilog. **Note:** You will be required to 'Register' prior to downloading.\\
  * A good series of short videos, by Cadence Design, on SystemVerilog can be found on [[https://www.youtube.com/watch?v=U18k9TDP5uw|YouTube]]