prism_labs
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
prism_labs [2021/03/17 17:36] – jaspal | prism_labs [2021/03/26 16:38] (current) – jaspal | ||
---|---|---|---|
Line 20: | Line 20: | ||
=== Technical Resources === | === Technical Resources === | ||
- | == Digital Design | + | == EECS3201 / EECS 3216 Digital Design |
- | This tutorial describes how to install Intel (Altera) Quartus Software, ModelSim, fpga Devices, related Drivers and to Verify your setup | + | **Note:** The following two tutorials are oriented towards **WindowsOS**. For **MacOS** see the next section. |
- | The tutorial is specifically for **//Quartus version 20.1 and for Max 10 family//** of FPGA devices. You would have to alter the steps, if using a different version and device family. | + | __Installing Software and Drivers__\\ |
+ | This tutorial describes how to install Intel (Altera) Quartus Software, ModelSim, fpga | ||
+ | Devices, related Drivers and to Verify your setup | ||
+ | |||
+ | The tutorial is specifically for **//Quartus version 20.1 and for Max 10 family//** of FPGA | ||
+ | devices. You would have to alter the steps, if using a different version and device family. | ||
To download the tutorial, click {{: | To download the tutorial, click {{: | ||
+ | __ModelSim Simulator__\\ | ||
+ | This tutorial explains running **// | ||
+ | simulate and verify your Digital Design. | ||
- | | + | Download the tutorial {{: |
+ | Click on this {{: | ||
- | Download | + | **__//Steps for MacOS//__** |
+ | Running Quartus and ModelSim on MacOS is __Not__ natively supported. However there are few work-arounds, | ||
+ | Follow | ||
+ | __Interactive Tutorials__\\ | ||
+ | * Check out this [[https:// | ||
+ | * A good series of short videos, by Cadence Design, on SystemVerilog can be found on [[https:// | ||
prism_labs.1616002591.txt.gz · Last modified: 2021/03/17 17:36 by jaspal