Lab 1

The lab report is due the end of the second lab session at the same time as the demo to the TA

A Verilof tutorial for DE2

submit as; submit 3215 LAB01 R1.pdf or docx

lab 2

Friday 18 and Monday 21st in the lab

The demo is by the end of the lab session, the report is due Monday 28

Digikey https://www.digikey.ca/products/en/development-boards-kits-programmers/evaluation-boards-embedded-mcu-dsp/786?k=kl43z&k=&pkeyword=kl43z&sv=0&pv1742=44&sf=0&FV=ffe00312&quantity=&ColumnSort=0&page=1&pageSize=25

Mouser https://www.mouser.ca/ProductDetail/NXP-Freescale/FRDM-KL43Z?qs=sGAEpiMZZMtzpSA5GSDwa4h%2fTfDsQpc4eHEHoEETWww%3d

lab sessions Friday Jan 25 and Monday Jan 28

Beofre you start take a look at htose videos

Prof. James Smith explaining FRDM kl43z and a first project video https://www.youtube.com/watch?v=u5DWSw9bkrs and https://www.youtube.com/watch?v=dEmPi6U1kTQ

FRDM kl43Z User Guide and datasheet

Board Schematic frdm-kl43z_sch.pdf

here is https://www.nxp.com/video/mcuxpresso-ide-creating-new-sdk-project:MCUXPRESSO-IDE-CREATING-SDK A video from NXP

Lab 3 note there is no lab report for this lab

This lab takes 2 weeks, in the first week you will learn how to solder the connector to the board. if you bought a board, please bring it with you.

Lab 4 —–

• The project is done in groups of 2, by default, a bigger group has to have a permission.

• The project should involve a microcontroller and some peripherals. Sensors or displays are some examples.

• Preferably, you should use the KL43Z, but that is not a condition. You can use any board, the easier/simpler the board is, the more involved the project should be

• You should have a proposal ready after the reading week. The one page should state what you will do and the parts you need to do it.

• Before you buy anything, check the compatibility with the board you are using